Why is My Dishwasher Leaking?

Coming downstairs to find a large puddle coming from the dishwasher is no-one’s favorite manner to start the day.

Luckily, most common causes of dishwasher leaks are comparably easy to diagnose and fix yourself. Meaning you might not have to hand wash the dishes that much, wait for the repair man or have to pay a high call-out charge.

So, grab the instruction manual if you have it, clean up the puddle and get something clean up any further spills and so see if you can’t find a DIY solution. If you can’t call us for local dishwasher repair.

Commonly Seen Sources of Dishwasher Faults and How to Resolve Them

Some of the most commonly seen explanations of dishwasher leaks aren’t actually because of a broken dishwasher at all. Before you start getting the tools out and flicking through endless youtube tutorials there are a few things you might want to rule out first.

  1. Investigate to find out if your dishwasher is level. If the dishwasher is misaligned water can quickly pool as well as spill out without there being anything that needs to be mended or replaced.
  2. Test you have been using the correct detergent. You might have seen this with your washing machine. An excess of soap or the incorrect variety may result in an excess of soap suds, the suds bubble over and you get a spill.
  3. Check your dishwasher door fully closes. If it does not you may have an object blocking it, or you could need to adjust the hinge or the locking mechanism.
  4. Investigate the filter at the bottom of the machine for any visible obstructions as if your dishwasher isn’t emptying effectively this is likely to result in fill too much and leak.

When you have looked at these possible causes it’s time to roll up your sleeves and begin a thorough check.

To make your life easier start with the door and check for any obvious issues in the interior of the machine prior to moving on to the underneath. If you are able to find and so resolve the problem without pulling out the dishwasher you’ll save yourself a lot of hassle.

And make sure you disconnect the appliance first by either unplugging it or turning off the circuit breaker for the dishwasher.

Door Seal

The door is seemingly the most common place for a dishwasher to leak and one of the simplest problems to solve.

If the leak is intermittent the issue may be as straightforward as a big pan or another object pushing into the door and preventing it from shutting properly.

On the other hand the door gasket could have been dislodged or been damaged.

Check the door seal and also investigate for any cracks, a build-up of limescale or other debris, or any areas where the seal might have separated from the door.

Removing the gasket and allowing it a comprehensive clean can help in some instances or you might have to buy a new seal and replace it.

Water Inlet Valve (Solenoid Fill Valve)

The water inlet valve can be a further everyday problem. It is usually found on the underbelly of the machine therefore you will most likely have to unscrew the kick plate and could have to unscrew the door cover.

The fill valve opens and closes to let water into the tub at various times in the programme. The inlet valve might be leaking, evidenced by a slight drip, or it may be broken and so not operating properly while the dishwasher is running.

When the fill valve fails to shut fully this can result in the dishwasher overfilling and result in a leakage.

In General inlet valve are not able to be repaired, thus the whole part would need to be changed.

Leaking Hoses

Hoses are needed to fill, drain and also recirculate water along the programme.

Two issues can develop where hoses are concerned.

  1. The gaskets may get damaged or the contact points could come loose meaning it’s a good idea to check all the connection points first.
  2. The alternative issue than may often develop over time is that hoses could get degraded or cracked.

Luckily faulty hoses are relatively simple to get hold of and also change.

Pumps and Seals

You are able to visually test the rubber seals that are part of the water pumps or motor to see whether there is a leak and replace them if there is.

The Float Switch

Either the float or the float switch could be faulty causing the dishwasher to overfill.

A working float will lift up as the water level goes up until the desired or highest water level is reached. The tail of the float would then operate the switch. If something is blocking this or the float is broken this could be causing your issues.

Checking the switch would need electrical equipment but it could be obviously damaged in which case replacing it should stop the leak.

Alternative Components that May Result in Leakage

A broken wash arm or support could puch water under the door causing leakage. This could likewise often result in your dishes not being cleaned as effectively as they should.

Broken or cracked lines may also result in this fault as may a loose pump cap.

The motor shaft gasket may have cracked resulting in a leak. This will generally show as a puddle coming from underneath the dishwasher.

Top Tips to Mend Your Dishwasher

  1. Spend less by changing the gasket rather than the whole component. In plenty situations, you can purchase the seal without the rest of the part which saves time as well as money.
  2. Check the quick fixes before you get more complicated. You don’t need to pull the whole dishwasher out if the problem is the detergent.
  3. Photograph your progress. This might assist you to reverse the process, describe the component you need in a shop, and also identify the issue to an engineer if required.
  4. Be careful. Water and electricity are not good friends so unplug the machine first.
  5. If you’re not sure get in a professional.

What To Do Next If Your Initial Investigation Fails to Disclose or Fix the Leakage

If the root of the problem can’t be uncovered the next step you could take is to pull out the dishwasher to get a better look beneath it as well as add water to the tub to see whether the leak becomes visible.

If you don’t uncover any leaks with this method your appliance might only leak when during a cycle. In this instance, you may wish to hire a appliance repair person to diagnose and also resolve the fault due to the safety risks of checking for faults with electrical elements uncovered.

More Dishwasher Problems:

  • Dishwasher Being Loud
  • Dishwasher Not Turning On
  • Dishwasher Not Draining
  • Dishwasher Not Drying
CLICK-TO-CALL